High-Speed Input/Output Designation Method - Mitsubishi Electric MELDAS C6 Programming Manual

3.3 High-Speed Input/output Designation Method

High-speed input/output is designated by setting the corresponding bit of the bit selection parameter
as shown below.
(1) High-speed input designation
Bit
selection
parameter
#6457
#6458
(2) High-speed output designation
Bit
selection
parameter
#6461
#6462
· As listed above, one bit corresponds to two bytes (16 points).
· Input or output in which 1 is set in the table is not performed at the main processing program
level.
· Although the number of bits set to 1 is not limited, set only necessary ones from viewpoint of
overhead.
· High-speed input/output designation corresponds to the bit selection parameter and can be
set in the parameter. However, it is recommended to set in a sequence program to prevent a
parameter setting error, etc.
Example: —[MOV H3 R4628]— ..... To designate X00~X0F, X10~X1F
3. Input/Output Signals
3.3 High-Speed Input/output Designation Method
7 6 5 4
7 6 5 4
Bits 0 and 1
Get other manuals https://www.bkmanuals.com
3 2 1
3 2 1
- 57 -
0
These bits
correspond to the
low-order byte
(bits 0 to 7) of file
register R4628
These bits
correspond to the
high-order byte
(bits 8 to F) of file
register R4628
0
These bits
correspond to the
low-order byte
(bits 0 to 7) of file
register R4630
These bits
correspond to the
high-order byte
(bits 8 to F) of file
register R4630