Mitsubishi Electric MELDAS C6 Programming Manual page 430

12.3.5 Handle Feed Axis Selection
The axis is designated for the following devices when handle feed is carried out with a PLC axis.
Y42D
Y42E
Y42F
When Y42D to Y42F are ON, each handle changes to PLC axis dedication.
"Y740 to 744 and 747" for the 1st handle usually used in the control device are used for
the axis selection of each handle.
("Y748 to 74C and 7AF" for the 2nd handle, "Y750 to 754 and 757" for the 3rd handle)
PLC axes are counted as PLC such as first axis and second axis. Therefore, if you will
operate the first handle in the first axis of PLC, turn ON Y42D, Y740 to Y744 and Y747.
(Note) The handle feed magnification is also used for NC control axes.
12. PLC Axis Control
12.3 PLC Interface
Device No.
HS1P 1st handle PLC axis valid
HS2P 2nd handle PLC axis valid
HS3P 3rd handle PLC axis valid
- 421 -
Get other manuals https://www.bkmanuals.com
Signal name