(1) Comment display part
Comment in the comment display part is prepared by the user with the comment display function.
Refer to the section "1.4 Creating PLC-related Data".
(2) Spindle tool, standby tool display part
The number of display items can be changed according to the control parameter value.
Control parameter (R4700)
F
E
D
(3) Magazine tool number display part
The number of displayed magazine tools and the magazine number start value can be changed
according to the number-of-magazine parameter and control parameter values.
(a) Number of magazines
Number-of-magazine parameter (R4710): The value can be set in the range of 0 to 80.
(Note) If 0 is set, the magazine number is not displayed. However, the magazine number
and magazine tool number guide part is displayed.
(b) Magazine number start value
Control parameter (R4700)
F
E
D
Example) Magazine number display when the number of magazines is 12.
MG TOOL-D
1
2
~
The magazine number
starts at 1.
10. Exclusive Commands 2
10.1 ATC Exclusive Command
C
B
A
9
8
00: Only spindle tool is displayed.
01: Spindle tool and standby 1 are displayed.
02: Spindle tool and standby 1 and 2 are displayed.
03: Spindle tool and standby 1~3 are displayed.
04: Spindle tool and standby 1~4 are displayed.
05 or more: No spindle tool or standby tool is displayed.
Hexadecimal expression
7
6
5
4
MG TOOL-D
MG TOOL-D
~
0
11
1
12
The magazine number
starts at 0.
- 352 -
Get other manuals https://www.bkmanuals.com
4
3
2
1
0
3
2
1
0
0: The magazine number starts at 1.
1: The magazine number starts at 0.
MG TOOL-D
~
10
~
11