Mitsubishi Electric MELDAS C6 Programming Manual page 457

Appendix 3. PLC Development Environment using GPPQ
3.5.3 Ladder Read from the C64 Controller
The method of reading a ladder from the M600 controller to the GPPQ is explained below.
(1) Menu Selection
The screen is selected from the menu using the following GPPQ basic operation.
Alt
Mode screen
(2) Screen Operation
The file names are designated and executed on the following screen.
File name designation method
Input the file name stored in the read target memory.
Display the read target memory list screen by pressing Ctrl + D .
Display the file list screen by pressing Ctrl + L .
After selecting the file using ↑ and ↓ , display the file name selected in the file name
designation column by pressing Enter .
[Read from PC]
Interface
Target PC
Target Mem
1. File 1. File Name [
2. Tgt
2. Device Mem
[Restrictions]
The following options of [2. Tgt] under [1. File] can be selected.
[2. Seq/SPC Prog] and [1. Whole Range], [3. Device Comment]
3.5 PLC Program Development Procedure
PC menu
( GRPH ) 2
window
Menu PC
RS232C <--->
Network : 0 Station : FF
Internal RAM
]
1. [ * ] Parameter
2. [ * ] Seq/SFC Prog
3. [ ] Device Comment
4. [ ] Dev Init Value
5. [ ] Simulation Data
6. [ ] File Register
1. [ ] Internal
Execute(Y)
Ctrl+L : filelist Ctrl+D : directo Space : sele Esc : close
- 448 -
Get other manuals https://www.bkmanuals.com
PC read
1
screen
Read
QnACPU
PC Type : Q4A
Title [
Title [
1. ( * ) Whole Range
2. ( ) Step Range
3. ( ) Step Range
4. ( ) Block Range
1. ( * ) Whole Range
2. ( ) Specify ZR[
1. ( * ) Whole Range
2. ( ) Specify Detail Range
Cancel(N)
]
]
[ ] – [ ]
P [ ] – [ ]
[ ] – [ ]
] – [ ]