Mitsubishi Electric MELDAS C6 Programming Manual page 470

Appendix 3. PLC Development Environment using GPPQ
3.6.6 Transfer to the Controller
The following shows the method of transferring a message from the GPPQ to the CNC controller.
The transfer method is the same as that of the ladder code. Ladder codes and message data are
distinguished by their file names only.
(1) Menu Selection
The screen is selected from the menu using the following basic operation.
Alt ( GRPH )
Mode screen
(2) Screen Operation
Transfer is executed in the following screen.
An example of transferring a message 1st language file "M1TEST.GPG" is shown here.
[Write to PC]
Interface RS232C
Target PC Network : 0
Target Mem Internal RAM
1. File 1. File Name [
2. Tgt 1. [ * ] Parameter
2. [ * ] Seq/SFC Prog
3. [ ] Device Comment
4. [ ] Dev Init Value
5. [ ] Simulation Data
6. [ ] File Register
1. [ ] Internal
2. Device Mem
3.6 PLC-Related Data Development Procedure
PC menu
２
window
Menu
PC
<---> QnACPU
Station : FF
Title [ ON BOARD S-RAM + (D-RAM)
] Title [
1. ( * ) Whole Range
2. ( ) Step Range
3. ( ) Step Range
4. ( ) Block Range
1. ( * ) Whole Range
2. ( ) Specify
1. ( * ) Whole Range
2. ( ) Specify Detail Range
Cancel(N)
Execute(Y)
Ctrl+L : filelist Ctrl+D : directo Space : sele Esc:close
- 461 -
Get other manuals https://www.bkmanuals.com
PC menu
２
screen
Write
PC Type : Q4A
[ ] – [
P [ ] – [
[ ] – [
ZR[ ] – [
]
]
]
]
]
]