Mitsubishi Electric MELDAS C6 Programming Manual page 333

Execution conditions
The execution condition for OPEN is as shown below.
Command OFF
OPEN
Program example
Program to open a connection to send data with port No. :6000 and connection No.:5.
14
ZP.OPEN
No. of
Command
steps
1 MOPV
4 MOV
7 DMOV
11 MOV
14 ZP.OPEN
26
Cautions
(1) Even if the dedicated commands (OPEN, CLOSE, BUFSND, BUFRCV) are executed with the
high-speed PLC, the actual operation will take place at the same timing as the medium-speed
PLC. Thus, the dedicated command should be executed with the medium-speed PLC.
(2) Open transmission using TCP after the client device's reception has been opened. If
transmission is opened before reception is opened, an error completion (completion status
C033) will occur.
If transmission is opened for a client device with a nonexistent IP address, an error completion
(completion status C033) will occur after one minute.
(3) If a connection opened with TCP is closed, and is tried to be opened again within a minute, an
error completion (completion status C017) will occur. Wait a while before opening the connection
again.
(4) If the connection No. is not within the specified range, an error completion (completion status
C1A6) will occur, but the completion device and completion device +1 will not turn ON.
9. Exclusive Commands 1
OPEN
ON
"U20" K5 D100
Device
H8000 D100
H100 D102
H0C0A80103 D104
K6000 D106
"U20" K5
- 324 -
Get other manuals https://www.bkmanuals.com
M150
D100 M150