Table of Contents
Advertisement
INTRODUCTION
1
1.1 Operating requirements
The software described in this document was designed for use with precision air-conditioning units such as "Close Control" units
(for data processing centres).
The software was designed for use on the following control systems:
•
Control board EVOLUTION+ – Small with user terminals and PGD1 graphic interface.
•
Control board EVOLUTION+ – Medium with user terminals and PGD1 graphic interface.
•
Control board EVOLUTION+ – Large with user terminals and PGD1 graphic interface.
INFORMATION:
The EVOLUTION+ controller software is protected by a digital signature.
This means that it can only work on boards supplied by MEHITS and not on boards purchased from
other dealers.
1.2 General functions
Below is a non-exhaustive list of the functions of the application:
•
Adjustment of room temperature and humidity according to the setpoints entered using the user terminal.
•
Complete visualisation of the operating status of the unit.
•
Possibility of setting the adjustment parameters. Possibility of setting both the fundamental ones, by entering the
"User" password, and the more advanced ones, by entering the "Service" and "Factory" password (Manufacturer).
•
Possibility of manually managing (manual override) all the unit devices.
•
Management and acoustic and visual signalling (visual only by default) of faults (alarms), events and maintenance. It
can store up to 200 events.
•
Possibility of serial control and management.
•
Possibility of operation of up to 10 units connected together in a local LAN network. Even with one or two backup units
rotating on a time basis.
Version 38
9
Advertisement
Table of Contents
