Mitsubishi Electric Evolution+ s-MEXT Technical Manual page 47

Mask of the terminal
Config
--------------- P10.48
Phase sequence 2 mana-
gement on unit:
Config.
--------------- P10.50
Number of return NTC
probes :
--------------- P10.51
Number of supply NTC
probes :
Config. – Pwd change
Insert a new
Factory password:
0000000000
Config. – About
Evolution+
Code ME 38.00.009 EN
HW pCO5+ S
NAND 50MB
Flash 2MB + 7MB + 4MB
Ram 2048KB
Boot 05.01 Bios 06.52
Version 38
Parameter for managing the phase sequence control in power supply
line 2.
Y
Parameter for indicating the number of return air NTC probes installed
in the unit.
4
Parameter for indicating the number of delivery air NTC probes
4
installed in the unit.
Sets a new "Factory" password.
Attention: the value set in this field is the one and only to access the
"Factory" group.
This mask contains the reference information of the software [Code
ME 38.00 EN].
The closed padlock symbol shows that the board is provided with its
proprietary software.
The hardware information is also shown, namely the size (S, M, L), the
memories (NAND, Flash and RAM), and finally the versions of the
basic software of the controller (Boot and Bios).
Description Par.N.
10.48
10.50
10.51
47