Table of Contents
Advertisement
Main
Loop
•
The "Unit" menu displays the following information: temperature, pressure and circuit states.
•
"Setpoint
The
It is possible to set different setpoints depending on the available function modes (heat resources present, humidifier
present, and dehumidifier present, etc.).
•
The "In/Out menu" shows the status of the digital inputs and values read from the analogue inputs.
It also shows the status of the digital outputs and the voltage supplied to the analogue outputs.
If I/O expansions are present (depending on the configuration parameters), the inputs and outputs of the latter are also
shown.
•
The "Clock" menu is used to set and display the date and time and configure the time bands.
•
The "Log menu" is used to display the list of alarm events recorded by the unit.
•
In the "User" group there are menus in which it is possible to display and set parameters related to the user
programming of the unit.
•
In the "Service" group there are menus in which it is possible to display and set parameters for the service
configuration of the unit.
•
In the "Factory" group there are menus in which it is possible to display and set parameters for the manufacturer's
configuration of the unit.
Version 38
[ESC]
[ESC]
[ESC]
[ESC]
[ESC]
[ESC]
[ESC]
[ESC]
Figure 2-3: tree for moving around the "Main" group.
Menu"
is
used
to
set
Main
Group
Unit
[ESC] / [ENTER]
Selection
Setpoint
[ESC] / [ENTER]
Selection
In/Out
[ESC] / [ENTER]
Selection
Clock
[ESC] / [ENTER]
Selection
History
[ESC] / [ENTER]
Selection
User
[ESC] / [ENTER]
Selection
Service
[ESC] / [ENTER]
Selection
Factory
[ESC] / [ENTER]
Selection
the
setpoints
for
the
Unit
Menu
Setpoint
Menu
In/Out
Menu
Clock
Menu
History
Menu
User
User
[ENTER]
Password
Group
[ESC]
Service
Service
[ENTER]
Password
Group
[ESC]
Factory
Factory
[ENTER]
Password
Group
[ESC]
various
available
functions.
15
Advertisement
Table of Contents
