Mitsubishi Electric Evolution+ s-MEXT Technical Manual page 35

Area 1: general machine status
NOTE:
If the icon flashes at the same time as the
heaters (see the relevant paragraph in the "Heating" chapter).
Area 2: detailed status of the unit
Presence of an active alarm.
Maintenance signal.
Active manual controls.
Unit on/off from terminal.
Unit on/off from remote contact.
Unit on/off from supervision system.
Unit on/off from KIPlink.
Unit on in local LAN.
Unit turned on for LAN disconnection
alarm.
Unit on stand-by.
Version 38
Unit off
Unit operating in normal mode
Unit operating in maximum fan speed mode for fan alarm
Normal operation
Unit operating on
steady capacity Maximum flow reached
mode
Minimum flow reached
Unit operating on
Normal operation
steady residual ∆P
Minimum flow reached
mode
icons, this means that the unit is on for Post-Ventilation of the electric
Unit in Demand Limit mode.
Unit on for exceeding the maximum room
temperature threshold
high ambient temperature.
Unit on for exceeding the maximum room
temperature threshold
low ambient temperature.
Unit on for exceeding the maximum room
temperature threshold
high ambient humidity.
Unit on for exceeding the maximum room
temperature threshold
low ambient humidity.
Unit on for electric heater post-ventilation
function.
Unit off and powered by ULTRACAP.
35