Mitsubishi Electric Evolution+ s-MEXT Technical Manual page 61

Mask of the terminal
Settings
------------ P22.31-42
KIPlink
Ethernet channel
IP: 192.168.030.001
SUB: 255.255.255.000
GW: 000.000.000.000
Settings
------------ P22.62-73
KIPlink
WiFi channel
IP: 192.168.030.001
SUB: 255.255.255.000
GW: 000.000.000.000
Settings
------------ P22.59-61
KIPlink Network Master
serial num.: 032000000
--------------- P22.44
Communication channel
to join: WiFi ch.
Settings
------------ P22.45-48
KIPlink Network Master
module – IP Address:
192.168.030.001
--------------- P22.49
ID: 01
Settings
----------------------
Send network config
to KIPlink:
Settings
----------------------
Start KIPlink
upgrade:
Settings
----------------------
Reset to default value
KIPlink Supervisor
ReadWrite password:
Version 38
Configuration of the ETH channel of the KIPlink module.
Configuration of the WiFi channel of the KIPlink module.
Serial number of the Priority unit of the KIPlink network.
Communication channel to activate.
Visible only when both the ETH and the WiFi communication channels are
enabled.
IP address of the KIPlink Priority module.
Identification number in the KIPlink network.
Send the new IP configuration to the KIPlink module connected to the controller.
N
Start updating the KIPlink.
N
Resets the password for use of the KIPlink in read and write mode.
N
Description Par.N.
22.31
22.32
22.33
22.34
22.35
22.36
22.37
22.38
22.39
22.40
22.41
22.42
22.62
22.63
22.64
22.65
22.66
22.67
22.68
22.69
22.70
22.71
22.72
22.73
22.59
22.60
22.61
22.44
22.45
22.46
22.47
22.48
22.49
61