Introduction - Mitsubishi Electric AE-200A Instruction Book

1. Introduction

To use the billing information objects (accumulator objects and trend log objects (excluding Trend Log Room
Temp)) for the BACnet
the procedure in this document, in addition to the procedure described in "7. Billing function trial run" in the
AE-200/AE-50/EW-50 Instruction Book –Apportioned Electricity Billing Function–.
To perform a trial run, you need to obtain this document and the AE-200/AE-50/EW-50 Instruction Book
–Apportioned Electricity Billing Function–.
To use the billing information objects for the BACnet
AE-200/AE-50/EW-50. For the license registration procedure, refer to the AE-200/AE-50/EW-50 Instruction Book
–Initial Settings–.
Entire flow diagram of initial settings and trial run for the AE-200/AE-50/EW-50 (when using the apportioned
electricity billing function and BACnet
Initial settings
for apportioned
electricity billing
function
Billing function trial run
Apportioned electricity billing
function (AE-200 system)
To a test with the building management system
*1 Before performing a trial run for the apportioned electricity billing function (BACnet
and check that the group settings/interlocked unit settings are correct (the correspondence of the actual air conditioning units/interlocked
units with the group numbers is correct) from the AE-200/AE-50's LCD or from the Integrated Centralized Control Web.
*2 When using the billing information objects for the BACnet
management block. If there are OA processing units registered as interlocked LOSSNAY, register a single OA processing unit in a single
block. (because this operation is required in 4-3-3 "Checking the match with the CSV data (apportioned results) of the AE-200".
*3 Enable accumulator objects and trend log objects.
*4 Perform a continuous operation for each indoor unit for at least 2 hours before performing the check after 00:00 on the day of the 1st
check (after air conditioning unit continuous operation).
WT08246X03
®
function in the apportioned electricity billing function of the AE-200/AE-50/EW-50, follow
®
function)
Normal initial settings and trial run
for all AE-200 systems
AE-200 settings
Settings on the Initial Setting Tool
(with apportioned electricity
billing function)
Settings
on the Charge Calculation Tool
Initial Settings
®
for BACnet function
Apportioned electricity
trial run
®
BACnet function trial run
®
function, you need to register the "Charge" license with the
*1
*2
When changing the "Log_interval" property of the
trend log object to 180000 (30 minutes), change it
after performing the initial settings for the BACnet
*3
function.
billing function
®
(BACnet ) trial run
*4
The order of this and "Billing function trial run"
may be changed.
®
function, set a single group in a single block when setting the energy
4
When using the apportioned electricity billing
function only from BACnet
required.
Scope covered by this document
®
), perform a trial run for the air conditioning system
®
, the settings are not
®