[P26] Lan Menu - Mitsubishi Electric Evolution+ s-MEXT Technical Manual

2.5.16

[P26] LAN Menu

Accessible from: "Service" group.
Mask of the terminal
LAN
 
LAN
Editable only from the
Master unit (Add.01)
LAN
--------------- P26.01
Amount of units
in the LAN: 01
LAN
--------------- P26.03
Stand-by mode in LAN
enable: N
--------------- P26.04
Stand-by mode in LAN
cycle time: 168h
LAN
--------------- P26.05
Amount of units in
stand-by in the LAN:00
--------------- P26.06
Stand-by mode in LAN
limits enable:
LAN
--------------- P26.02
Average values calcul.
from LAN enable:
--------------- P26.08
Max temp. value calc.
from LAN enable:
LAN
--------------- P26.11
H&L Local Temperature
protection enable:
LAN
--------------- P26.12
Diff. for ON with High
local temp.: 02.0°C
--------------- P26.13
Diff. for ON with Low
local temp.: 02.0°C
Version 38
Access mask to "LAN" (Local Area Network) menu.
This mask indicates that the LAN menu parameters can be edited only on the
Priority unit.
Only displayed on Secondary units.
Parameter for configuring the number of units in LAN.
Enable the standby mode function in LAN.
Standby cycle time in LAN.
Parameter for configuring the number of units in standby in the LAN.
Parameter for configuring the standby mode limit function in the LAN.
Y
Visible only if standby mode is enabled in the LAN.
Parameter for enabling the average calculation function in LAN.
N
Parameter for enabling the maximum air control temperature calculation function in
LAN.
N
Visible only if LAN is enabled.
Parameter for enabling Hot&Cold spot management.
N
Visible only if the average calculation function is enabled in LAN.
Parameter for configuring the offset from the average temperature for activation of
the Hot Spot function.
Parameter for configuring the offset from the average temperature for activation of
the Cold Spot function.
Visible only if Hot&Cold spot management is enabled.
Description Par.N.
26.01
26.03
26.04
26.05
26.06
26.02
26.08
26.11
26.12
26.13
71