Roland VM-C7100 Owner's Manual page 46

Chapter 3 Data Storage and Retrieval
4. Select the number of the library to which you want to save the settings.
First, turn the V1 knob (SELECT GROUP) to select U ("User"). Then turn the V2 knob
(SELECT NUMBER) to select the number corresponding to the desired library name
on the display.
To audition a library before it is overwritten (or erased), press [F1] (PREVIEW)
(highlighted in black) to hear the library. To initialize the channel delay, turn the
button off.
5. After selection, press [F3] (SAVE).
This opens the screen for saving the library. You can name the library on this screen
if necessary (see the next section).
6. Press [F5] (SAVE) to save the current settings.
After a confirming message appears, press [F5] (ENTER).
The delay settings of the channel are then copied to the selected library. This erases
any existing data in the selected library
Naming a library as it is saved
While saving (see the preceding section), each library can be named using up to 12
characters – this allows is to be easily identified.
1. Open the save screen of each library (Step 3 in the previous section).
fig.03-03
(Example: a delay library)
1. Select the character position (digit).
Turn the V1 knob (CURSOR POS) to move the cursor to the desired character
position.
2. Use the following knobs to enter a character:
Upper-case alphabet (A to Z):
Lower-case alphabet (a to z):
Values and symbols (1, 2, 3, "!", "#", etc.): V4 knob
Functions of [F2] to [F4]
• [F2] (DELETE): Deletes the character at the cursor position and moves the
following characters back to fill the newly created space.
• [F3] (INSERT): Inserts a space at the cursor position and pushes the following
characters forward to make room for the new characters.
• [F4] (SPACE): Replaces the character at the cursor position with a space.
46
V2 knob
V3 knob
Press [F1] (ASCII)
(highlighted in black) to
enable the entering of
characters using buttons.
With this function,
characters printed to the
left of various buttons on
the panel – CH EDIT,
STATUS, ten-key pad, etc.
– can be entered by
pressing each button.