Roland VM-C7100 Owner's Manual page 91

Chapter 6 Mixing Procedure 2 (Output and Monitor)
4. While holding down [SHIFT], press [PREAMP GAIN] in the PARAM
VIEW on Fader area to select SURROUND DEPTH.
fig.06-11
5. Change the front/rear position of each channel using its fader.
Calling up the CHANNEL EDIT mode screen
1. Press [FLEX BUS] MASTER 1–12 in the SECTION area.
2. Press the desired Flex Bus channel's [CH EDIT].
3. Use [PAGE UP] or [PAGE DOWN] to select the [SURROUND] page.
fig.06-12
The following operations and screens are the same as those for surround-panning of
an input channel. For details, refer to p. 74.
90
A Flex Bus can also be
surround-panned on
CHANNEL EDIT mode's
SURROUND page on the
while viewing each
channel's surround settings
graphically. You can also
set surround-panning for
linked channels, and fine
tune surround output
levels.
The screen on the left
shows a situation is which
the 3+2+1 surround mode
is selected. When either the
2+2 or 3+1 mode is
selected, the unused Flex
Bus output is left blank on
the display.
You can jump to this
screen can be called by
pressing the [SURROUND]
STATUS button while
holding down the Flex Bus
channel's [CH EDIT].