Roland VM-C7100 Owner's Manual page 126

Chorus:
Sw (Switch)
Rate (Rate)
Depth (Depth)
Feedback Level Lch (Lch Feedback Level)
Feedback Level Rch1 (Rch Feedback Level)
Pre-Delay (Pre-Delay)
Effect Level (Effect Level)
Direct Level (Direct Level)
CrossFB Level Lch (Lch Cross-Feedback Level)-100–100
CrossFB Level Rch(Rch Cross-Feedback Level)-100–100
3 BAND EQ (Equalizer)
Sw (Switch)
Hi Gain (High Gain)
Hi Freq (high frequency)
Hi Q (High Q)
Hi Type (High Type)
Mid Gain (Middle Gain)
Mid Freq (middle frequency)
Mid Q (Middle Q)
Lo Gain (Low Gain)
Lo Freq (low frequency)
Lo Q (Low Q)
Lo Type (Low Type)
Output Level (Output Level)
*1: The sum of the Delay Time (Time) value and the Delay Shift (Shift) value should not exceed the setting range of
Delay Time. For example, if the delay time is set to 300 ms, the setting range of Delay Shift is L200 to R200 ms.
*2: If Lo Type (Low Type) or Hi Type (High Type) is set to "Shelv (Shelving Type)," the setting for Lo Q or High Q
is invalid.
Frequency (p. 237), Q (p. 243), Shelving Type (p. 244), Peaking Type (p. 242), Delay (p. 234), Chorus (p. 233),
Equalizer (p. 236), Feedback Level (p. 236), Phase (p. 242)
Adds spaciousness and depth to the sound.
On, Off
0.1–10.0 kHz
0–100
-100–100
-100–100
0–50 ms
-100–100
-100–100
On, Off
-12 - +12 dB
1.4 - 20.0 kHz
0.3–10.0
Shelv, Peak
-12– +12 dB
200 - 8000 Hz
0.3–10.0
-12– +12 dB
20 - 2000 Hz
0.3–10.0
Shelv, Peak
0–100
Chapter 8 Using the Internal Effects
Turns the chorus on or off.
Sets the rate of modulation.
Sets the depth of modulation.
Sets the amount of the left-side chorus sound should be
returned to the left chorus input.
Sets the amount of the right-side chorus sound should be
returned to the right chorus input.
Sets the time delay from when the direct sound begins until
the processed sound is heard.
Sets the volume of the chorus sound.
Sets the volume of the direct sound.
Sets the amount of the left-side chorus sound should be
returned to the right chorus input.
Sets the amount of the right-side chorus sound should be
returned to the left chorus input.
Turns the equalizer on or off.
Sets the boost/cut amount in the high frequency band.
Sets the center frequency in the high frequency band.
Sets the width of the area around the high frequency that
will be affected by the gain settings.
Sets the type of the high frequency band equalizer
(shelving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.
Sets the type of the low frequency band equalizer
(shelving type or peaking type).
Sets the volume after passing through the equalizer.
*2
*2
125