Roland VM-C7100 Owner's Manual page 210

5
VIEW section
Data to be displayed in the VIEWER area are specified in this section.
SECTION:
2ndUNIT:
PARAM:
ALL:
6
SOURCE section
The channel subject to auto-mixing editing (source channel) is specified in this
section.
7
TIME/VALUE TRIM section
When you select data, you can confirm the name, location and value of the data at
the same time.
fig.11-03be
Position
Data Name
8
This mark indicates the location of the selected data.
9
This mark indicates the current position.
1. Press [AUTO-MIX] while holding down [SHIFT].
2. Press [PAGE UP]/[PAGE DOWN] to move the cursor to "VIEW."
The AUTO MIX VIEW screen is displayed.
3. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
4. When more than one processor is connected, press [F1] (2ndUNIT) to select
the processor.
5. Turn the [V1] (SECTION) knob to select the section to be displayed.
6. Turn the [V2] (PARAM) knob to select the data type to be displayed.
7. Turn the [V3] (SOURCE) knob to select the channel for confirming data.
8. Turn the [V4] (EVENTSEL) knob to confirm data one by one.
This way, you can check the data of the specified type sequentially.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
section
A second cascade-connected processor is selected.
data type
Specify if all types of data should be/should not be
displayed in the VIEWER area.
Value
You can arrange things so
that changing the current
position would not cause
the screen to be scrolled. To
do so, set the [F5] (SYNC)
switch in the ZOOM
section off.
Turning the [V4]
(EVENTSEL) knob does not
affect the current position.
209