Roland VM-C7100 Owner's Manual page 153

Chapter 8 Using the Internal Effects
Reverb 2
This gate reverb works in either of two modes of gate operation (Gate/Ducking). In the Gate mode, the gate opens
when a certain volume (Threshold Level) is exceeded while in the Ducking mode, the gate opens when the
volume becomes as low as or lower than Threshold Level. Either of FX-1 through FX-8 can be used. For each of
FX-1 through FX-8, two types of reverbs with different settings can be used or a combination of reverbs can be
used.
fig.08-49
Input L
Input R
Reverb types
There are five reverb types: You can choose the type with Reverb Type.
Room1:
Room2:
Hall1:
Hall2:
Plate:
Selecting Gate type
Reverb sounds have different effects depending on the gate operation types. Use Gate Mode to select the type.
Gate:
Duckn:
152
Direct Level
Reverb 2
Direct Level
Ordinary room reverb
Room reverb with a softer tone compared with Room1
Ordinary hall reverb
Hall reverb with a softer tone compared with Hall1
Plate reverb
The gate opens when the volume of the direct sound exceeds the value set with
Threshold Level (Thres). The gate closes when the volume drops below the Threshold
Level value.
Operates in the opposite manner as in the "Gate" mode. The gate closes when the
volume of the direct sound exceeds the value set with Threshold Value. The gate opens
when the volume becomes as low as or lower than the Threshold Level value.
Output L
3BAND EQ
3BAND EQ
Output R