Roland VM-C7100 Owner's Manual page 164

Parameter (full name)
Vocoder:
Character Ch1 - 19
(Voice Character Channels 1 - 19)
SynInput level (Synthesizer In Level)
MicSens (Microphone Sensitivity)
Microphone Mix level (Microphone Mix)
Microphone PAN (Microphone Pan)
Microphone HPF Freq (Microphone HPF)
Envelope (Envelope)
PanMode (Pan Mode)
Hold (Hold)
Noise Suppressor Threshold
Chorus:
Sw (Switch)
Rate (Rate)
Depth (Depth)
Pre-Delay (Pre-Delay)
Mix Bal (Mix Balance)
• To switch the Voice Character Channels 1–19, turn the V1 (BAND) knob, or press [F1] (BAND-) or [F2] (BAND+).
Chorus (p. 233), Vocoder (p. 247), HPF (p. 238)
Setting
The pitch is specified as in the instrumental sound while the tone is output in
the human voice.
0–100
0–100
0–100
0–100
L63–R63
Thru, 1.0–20.0 kHz
Sharp, Soft, Long
Mono, Stereo
On, Off
0–100
Adds spaciousness and depth to the sound.
On, Off
0.1–10.0 Hz
0–100
0–50 ms
0–100
Chapter 8 Using the Internal Effects
Function
Sets the tone of the vocoder.
Sets the input level of the instrumental sound.
Sets the input sensitivity of the microphone.
Sets the amount of the sound after passing through the
microphone HPF should be mixed into the Vocoder output.
Sets the panning of vocal sounds through the microphone.
Sets the frequency at which HPF on the vocal sounds
through the microphone starts taking effect.
Sets this to "Thru" if HPF is not desired.
Defines characteristics of the sound.
Defines how the sound is located.
Specifies that an instrumental sound is or is not issued with
the formant fixed.
Sets the volume to start muting noise on the instrumental
sound input.
Turns the chorus on or off.
Sets the rate of modulation.
Sets the depth of modulation.
Sets the time delay from when the direct sound begins until
the chorus sound is heard.
Sets the volume balance between the chorus sound and
the direct sound.
163