Roland VM-C7100 Owner's Manual page 117

Chapter 8 Using the Internal Effects
4. Select [PARAM-1] or [PARAM-2] with PAGE DOWN.
The Edit Parameter page opens. (The Edit Parameter page may not contain the
[PARAM-2] page.) The parameter pages vary from algorithm to algorithm. (The
illustration below shows an example of Mic Simulator). For descriptions of the on-
screen parameters, see Algorithm List on and after p. 119.
fig.08-006
The [FLOW/SW] area at the top of the screen indicates the order in which the effects
are assigned in the algorithm. In this example, the effects are assigned on two signal
paths (A and B) in the following order: Cnv, BCut, Dstan, and Lmt. You can turn the
effects on and off separately by positioning the cursor as shown in the illustration
and pressing the F buttons that are lit ([F1] to [F4] in this example).
Settings within the Edit Effect screen
You set the effect parameters by positioning the cursor and using the [V1] to
[V6] knobs and [F1] to [F6] buttons.
For example, you can set the parameters as shown below when [F1] and [F3] are lit
with the cursor selected as shown in the figure.
fig.08-007
[F1] (ON)
V1 (INPUT) and V2 (OUTPUT) knobs Change the parameter settings when
V3 (PHASE) knob and [F3] (SET)
116
Turns the effect of the Mic Converter
section on and off.
necessary.
Select Norm or Inv by turning the V3
knob and then press [F3] to validate your
choice.
For the descriptions of the
parameters in the window,
see the Algorithm List,
beginning on p. 119.