Roland VM-C7100 Owner's Manual page 172

Parameter (full name)
SP Modeling (Speaker Modeling): Selects the speaker subject to characteristics modeling.
Model (Model)
Output Speaker (Output Speaker)
Phase (Phase)
BassCut Freq (Bass Cut Filter): Cuts off undesired low sounds such as pop noise.
Sw (Switch)
Freq (Frequency)
Lo Freq Trim (low frequency Trimmer): Adjusts the low frequency band sounds.
Sw (Switch)
Gain (Gain)
Freq (Frequency)
Hi Freq Trim (high frequency Trimmer): Adjusts the high frequency band sounds.
Sw (Switch)
Gain (Gain)
Freq (Frequency)
Limiter:
Sw (Switch)
Level (Level)
Thres (Threshold)
Release (Release)
Speaker Modeling (p. 245), Bass Cut Filter (p. 233), Low frequency trimmer (p. 239),
High frequency trimmer (p. 238), Limiter (p. 238)
Setting
See the column on
the previous page.
See the column on
the previous page.
NRM, INV
On, Off
Thru, 20 - 2000 Hz
On, Off
-12– +12dB
20–2000 Hz
On, Off
-12– +12dB
1.0–20.0 kHz
Prevents distortion by suppressing signals at high levels.
On, Off
-60– +24 dB
-60–0 dB
1–100
Chapter 8 Using the Internal Effects
Function
Specifies the type of the speaker subject to characteristics
modeling.
Specifies the speaker actually generating sounds.
Sets the phase of the speaker. "NRM" for the same phase,
and "INV" for the inverted phase.
Turns the bass cut filter on or off.
Sets the frequency for cutting off undesired low frequency
band sounds such as pop noise.
Turns the low frequency trimmer on or off.
Sets the boost/cut amount.
Sets the center frequency of the trimmer.
Turns the high frequency trimmer on or off.
Sets the boost/cut amount.
Sets the center frequency.
Turns the limiter on or off.
Sets the volume after passing through the limiter.
Sets the volume at which the limiter starts working.
Sets the time from when the input level drops below the
threshold level to when the effect ceases to apply.
171