Roland VM-C7100 Owner's Manual page 141

Chapter 8 Using the Internal Effects
Parameter (full name)
Noise Suppressor:
Sw (Switch)
Thresh (Threshold)
Release (Release)
G-Amp (Pre-Amplifier):
Sw (Switch)
Volume (Volume)
Master (Master)
Gain (Gain)
Type (Pre-amplifier type)
Bass (Bass)
Middle (Middle)
Treble (Treble)
Presence (Presence)
Bright (Bright)
Speaker Simulator:
Sw (Switch)
Mic Level (Microphone Level)
Setting (Microphone Setting)
Direct Level (Direct Level)
Speaker Type (Speaker Type)
*1: Can be set only when JC-120, Clean Twin or BG Lead is selected for Pre-amplifier Type.
*2: Cannot be set when Match Drive is selected for the Pre-amplifier Type.
*3: The setting range is -100 to 0 when Match Drive is selected for the Pre-amplifier Type.
Noise Suppressor (p. 240), Pre-amplifier (p. 243), Speaker Simulator (p. 245)
140
Setting
Mutes noise in the silent mode.
On, Off
0–100
0–100
Simulates the pre-amplifier section of a guitar amplifier.
On, Off
0–100
0–100
Low, Middle, High
See the column on
the previous page.
0–100
0–100
0–100
0–100 (-100–0)
On, Off
Simulates a speaker.
On, Off
0–100
1, 2, 3
0–100
See the column on
the previous page.
Function
Turns the noise suppressor on or off.
Sets the level to start muting noise.
Sets the time over which the volume will drop to 0 after the
noise starts being muted.
Turns the compressor on or off.
Sets the volume and degree of distortion of the amplifier.
Sets the volume of the entire pre-amplifier
Sets the degree of sound distortion on the pre-amplifier.
Sets the type of the guitar amplifier.
Sets the tone of the low range.
Sets the tone of the middle range.
Sets the tone of the high range.
Sets the tone of the ultra-high range.
You can set this on to generate clear-cut bright sounds.
Turns the speaker simulator on or off.
Sets the microphone volume.
Sets the location of the microphone that is recording the
sound of the speaker.This can be adjusted in three steps,
with the microphone becoming more distant in the order of
1, 2, and 3.
Sets the volume of the direct sound.
Sets the speaker type.
*2
*3
*1