Roland VM-C7100 Owner's Manual page 67

Chapter 4 Useful Functions
How to set parameters
fig.04-11e
[V1]–[V6] knobs
Fader / [V1]–[V6] knobs
[F1]–[F6]
In most cases, the cursor is moved to the desired parameter and the [V1] to [V6]
knobs are used to change the setting of the selected parameter. In addition to this,
parameters can be set using faders in the "parameter view on fader" screens so that
several channels' parameters can be adjusted at the same time. To set switches such
as BUS SEND and MAIN SEND, the cursor is moved to the target parameter and [F1]
to [F6] is pressed.
Separating screen from fader state
When screens are switched, the fader settings typically change as well. When
simultaneously adjusting the levels of both analog and digital signals received via
the R-BUS, screens may need to be switched repeatedly, since both screens cannot be
displayed at the same time. To solve this problem, turn [on Display] on to separate
the screen state from the fader state. This allows the state of screens to be switched
with the state of the faders when [on Display] is turned on. This also allows you to
adjust the analog input levels using the [V1] to [V6] knobs on the screen, and the
digital input levels using the fader.
66
The fader states of MULTI
IN and INPUT can be
flipped using [FLIP] (only
when the VM-C7200
console is used).