Roland VM-C7100 Owner's Manual page 203

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
Statuses of channels
When the auto-mixing function is assigned to the status button of each channel
(when CH STATUS MODE is set to [AUTO-MIX]), the channel status can be
switched between the settings below. Use the status button of the channel to switch
the states. You can check the state with the indicator. Define the state suitable for the
desired operation for the respective channels.
Channel status
Not to play back/record (Off)
To play back
To record
fig.11-02b
Confirming channel statuses at a glance
Usually, you can check the channel status with the indicator of the status button for
each channel. In this case, only the status of the channel for the currently selected
section ca be checked. On the STAT1_U1 - STAT2_U2 screens, you can check the
channel statuses for more than one section.
1. Press [AUTO-MIX] while holding down [SHIFT].
2. Press [PAGE UP]/[PAGE DOWN] to display either the STAT1_U1 or
STAT2_U1 screen.
3. Check the channel status section by section.
"-" indicates Off, "R" Recording and "P" Playback, respectively.
202
Indicator
Turned off.
Green
Red
When auto-mixing is not
being played back/
recorded, the state is cycled
from Playback, Record, Off,
Playback... in this order
each time the status button
is pressed. When auto-
mixing is being played
back/recorded, the status is
switched only between
Playback and Recording
each time the status button
is pressed. It cannot be
turned to Off.
A channel in the Off status
cannot be switched during
auto-mixing playback/
recording.
In cascade connection, the
channel status of a second
unit can be checked on the
STAT1_U2/STAT2_U2
screen.