Roland VM-C7100 Owner's Manual page 205

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
Recording auto-mixing for the first time/recording by
overwriting (ABSOLUTE REC)
Absolute recording refers to recording of the operations of faders and knobs as they
were actually operated. This method is used when recording auto-mixing for the
first time or when recording by overwriting.
1. Press any of the buttons in SECTION to select one of the sections.
2. Press [AUTO-MIX] to set it to ABSOLUTE RECORDING (the indicator:
red).
3. Press [AUTO-MIX] under CH STATUS.
The status button for the channel is switched to the mode for auto-mixing.
4. Press the status button for the channel for which auto-mixing is to be
recorded to set it to the recording state (red indicator).
To record auto-mixing on another channel while playing it back, press the status
button for that channel to set it to the playback state (green indicator).
5. Press any of the buttons in "PARAMETER VIEW on Fader" to select the
type of data to be recorded.
6. Press [PLAY] to start recording auto-mixing.
The channel of the status button with the green indicator starts playback.
7. Operate the faders or knobs.
8. Press [STOP] to finish recording.
204
In some cases, previously
recorded auto-mixings may
still remain in the memory
following the position
where recording of auto-
mixing has been
completed. To avoid this
situation, go to the SETUP
screen and set [REMOVE
FOLLOW DATA] to "TO
END DATA" (p. 200).
Press [UNDO/REDO] to
cancel auto-mixing just
recorded (UNDO). Pressing
[UNDO/REDO] once more
restores the auto-mixing
just recorded (REDO).