Roland VM-C7100 Owner's Manual page 77

Chapter 5 Mixing Procedure 1 (Input Channel)
Preparing to send input channels to multi-outs in CHANNEL EDIT mode
1. Press [INPUT] in the SECTION area.
2. Press the desired channel's [CH EDIT].
3. Use [PAGE UP]/[PAGE DOWN] to select the MAIN/CUE page.
You can jump to this screen by pressing the [MAIN/CUE] STATUS button while
holding down the desired channel's [CH EDIT].
4. Use CURSOR [UP] to select the parameters in the upper section.
fig.05-13
5. Select the output channel to which you want to send the input channel's
signal.
Select the desired MULTI-OUT with the V1 (MULTI OUT SEL) knob, then press [F3]
(SET) to confirm your choice.
Setting the send level and point to a MULTI OUT
To set up SEND LEVEL to MULTI OUT using the V5 (LEVEL) knob, follow Step 5
above and press CURSOR [DOWN] to select the parameters in the middle section.
This allows you to select a point from within the channel's signal flow from which
its signal will be sent to the selected MULTI OUT.
fig.05-14
Turn the [V4] (SEND POSI) knob to select PreEQ, PreFD (Pre Fader) or PstFD (Post
Fader). Press [F4] (SET) to confirm your selection.
fig.05-15
Channel Input
ATT
76
FX FX
EQ MUTE
DELAY HPF
PRE FADER
PRE EQ
POST FADER
MULTI OUT 1–24
FADER
MAIN
SW
The following settings can
also be accessed for all
channels at once by
pressing [MULTI OUT] in
the SECTION area and
pressing [CH EDIT] for the
multi-out channel you
want to set up (p. 93).
You can press [F3] again to
cancel your output
selection, if you wish.