Roland VM-C7100 Owner's Manual page 106

Chapter 7 Mixing Procedure 3 (Settings Common to Input and Output)
Registering and deleting a fader group
Each channel fader can be registered in a fader group as follows:
1. Press [FADER GROUP] MASTER 1-24 in the SECTION area.
This calls up the fader group master screen and turns the channel strips into fader-
group master channels.
2. Press the desired fader-group master's [CH EDIT].
This calls up the channel fader registration/deletion screen.
fig.07-05
3. Select a set of six channels using CURSOR [UP], [DOWN], [LEFT] or
[RIGHT] from GROUP VIEW at the lower right of the screen.
In the above figure, Input Channels 13 to 18 are selected.
4. Registering or deleting a channel fader.
A selected channel fader can be registered or deleted in or from a fader group using
[F1] to [F6]. Repeat Steps 3 and 4 to assign channels to or delete them from the fader
group selected in Step 2. To change the registrations for another fader group, return
to step 2.
Naming a fader-group master
A fader-group master can be named. This can be helpful as a means of identifying
the channels it controls. Both long names (up to 12 characters) such as "AllVocal"
and short names (up to 3 characters) such as "Voc" can be set.
1. Press [FADER GROUP] MASTER 1-24 in the SECTION area.
2. Press the desired fader-group master's [CH EDIT].
This calls up the channel fader addition/deletion screen.
3. Use [PAGE DOWN] to select the NAME page.
fig.07-07
4. Use [F1] to [F5] and the V1 to V6 knobs to enter a name.
The remainder of the operation is exactly the same as the procedure used in naming
an input channel. For details, refer to "Naming input channels" (p. 83).
You cannot register a fader
in multiple fader groups.
By pressing [PAGE UP] or
[PAGE DOWN] and
selecting INPUT, MULTI,
F BUS or MIDI in Step 2 or
later, the current fader-
group state of each channel
fader can be checked. The
setting of a channel fader
can also be changed
CURSOR
directly using
[UP], [DOWN], [LEFT] or
[RIGHT] and the V1 to V6
knobs.
105