Roland VM-C7100 Owner's Manual page 180

Expander:
Sw (Switch)
Thres (Threshold)
Ratio (Ratio)
Attack (Attack)
Release (Release)
Compressor:
Sw (Switch)
Level (Level)
Thres (Threshold)
Ratio (Ratio)
Attack (Attack)
Release (Release)
Limiter:
Sw (Switch)
Thres (Threshold)
Attack (Attack)
Release (Release)
Output:
Output Level (Level)
Sft Clip (Soft Clip)
Bass Cut Filter (p. 233), Enhancer (p. 236), Expander (p. 236), Compressor (p. 233), Limiter (p. 238)
Expands the dynamic range at a certain ratio.
On, Off
-80–0 dB
1:1–16:1, INF:1
0–100 ms
50–5000 ms
Compresses the entire output signals when the input volume exceeds a
specified value.
On, Off
-80– +6 dB
-24–0 dB
1:1–16:1, INF:1
0–100 ms
50–5000 ms
Prevents distortion by suppressing signals at high levels.
On, Off
-24–0 dB
0–100 ms
50–5000 ms
Provides settings concerning overall output.
-80– +6 dB
On, Off
Chapter 8 Using the Internal Effects
Turns the expander on or off.
Sets the volume at which the expander starts working.
Sets the ratio at which the output is increased when the
input level has dropped below the threshold level.
Sets the time until when the expander starts working after
the input level has dropped below the threshold level.
Sets the time until when the expander stops working after
the input level has exceeded the threshold level.
Turns the compressor on or off.
Sets the volume of the compressor sound.
Sets the volume at which the compressor starts working.
Sets the ratio at which the output is suppressed when the
input level has exceeded the threshold level.
Sets the time until when the compressor starts working
after the input level has exceeded the threshold level.
Sets the time until when the compressor stops working after
the input level drops below the threshold level.
Turns the limiter on or off.
Sets the volume at which the limiter starts working.
Sets the time until when the limiter starts working after the
input level has exceeded threshold level.
Sets the time until when the limiter stops working after the
input level drops below the threshold level.
Sets the overall volume after passing through the limiter.
Suppresses conspicuous distortion that may occur when
the effect of compressor/limiter has been applied
excessively.
179