Roland VM-C7100 Owner's Manual page 72

5. Set the channel's SEND LEVEL and PAN to the main mix by adjusting:
• SEND LEVEL using the V1 (MAIN LEVEL) knob. SEND LEVEL can be set
anywhere from - to +6 dB.
• PAN using the V2 (MAIN PAN) knob. PAN can be set from L63 (far left) to R63
(far right).
While in CHANNEL EDIT mode, you can also set two other parameters that affect
sending the channel's signal to the main mix:
• SEND ON/OFF—This sets whether or not the channel's signal is sent to the
main mix. Press [F1] (ON)—when the channel's signal is being sent to the main
mix, the parameter is highlighted.
• PAN LINK—Adjacent channels can be stereo-linked in odd/even pairs—
Channels 1 and 2, Channel 3 and 4, Channels 5 and 6, and so on. When channels
are pan-linked, they're locked together at their current pan positions into a single
stereo image. If you lower or raise either channel's PAN setting, the entire stereo
image will be shifted left or right accordingly. To pan-link two channels, press F2
(PANLINK). When PAN LINK is active, the parameter will be highlighted.
6. Set the channel's SEND LEVEL and PAN to the cue bus by adjusting:
• SEND LEVEL using the V3 (CUE LEVEL) knob. Cue SEND LEVEL can be set
from - to +6 dB.
• PAN using the V4 (CUE PAN) knob. This can be set from L63 to R63.
You can also set two other parameters that affect sending the channel's signal to the
cue bus:
• SEND ON/OFF—This sets whether or not the channel's signal is sent to the cue
bus. Press [F3] (ON)—when the channel's signal is being sent to the cue bus, the
parameter is highlighted.
• PAN SLAVE—When this parameter is on—highlighted—the PAN setting for the
cue bus is automatically set to the same value as the PAN setting for the main
mix. Press [F4] CUE PAN SLAVE To MAIN to switch pan slaving on or off.
Switching the send point to the cue bus
You can select the point in the channel's signal flow from which its signal will be sent
to the cue bus. To do this, return to Step 6 above, press CURSOR [UP] and select the
middle parameter group. Turn the V3 (CUE SEND POSI) knob and [F3] (SET) to
choose from among a selection of locations in the channel signal flow.
fig.05-04
As you turn the V3 (CUE SEND POSI) knob, the setting is switched from PreEQ
("PRE EQ") to PreFD ("PRE FADER") and to PstFD ("POST FADER"). When you've
chosen the desired point, press [F3] (SET) to confirm your selection.
fig.05-05
Channel Input
ATT
Chapter 5 Mixing Procedure 1 (Input Channel)
FX FX
EQ MUTE
DELAY
HPF
PRE FADER
PRE EQ
POST FADER
CUE BUS
FADER
MAIN
SW
71