Roland VM-C7100 Owner's Manual page 89

Chapter 6 Mixing Procedure 2 (Output and Monitor)
Sending signals to MAIN OUT or cue bus
Flex Bus levels or panning can also be set from this screen.
1. Follow step 4 in the previous section, and use CURSOR [DOWN] to select
the parameters in the lower section of the display.
fig.06-08
2. Set the Flex Bus's send level and pan to the MAIN OUT jacks:
Flex Bus send to the main mix
Flex Bus panning in the main mix Use the V2 knob (MAIN PAN) to choose
The following parameters can also be set from this display:
On/off switch for sending the Flex Bus to the main mix
Pan-linking
3. Set the cue bus send level and panning.
Flex Bus send to the cue bus Turn the V3 knob (CUE LEVEL) to set the Flex
Flex Bus pan to the cue bus Turn the V4 knob (CUE PAN) to select the desired
The following parameters can also be set from this display:
On/off switch for sending the Flex Bus to the cue bus
Pan slave
88
Use the V1 knob (MAIN LEVEL) to select
the desired level from infinity to +6 dB.
the desired pan position, from L63 to R63.
Press [F1] (ON) to enable or disable the send. When the
send is active, it's highlighted.
Set this parameter by pressing [F2] (PANLINK). When Flex
Bus pan-linking is active, it's highlighted on the display.
When pan-linking is in effect, the V2 knob affects the stereo
placement of both linked Flex Buses in the main mix.
Bus's send to the cue bus, from infinity to +6 dB.
pan position for the Flex Bus, from L63 to R63.
Press [F3] (ON) to activate or de-activate the send to the cue
bus. When the send is active, it's highlighted on the display.
Press [F4] CUE PAN SLAVE To MAIN (ON) to activate
pan-slaving; when it's on, it's highlighted on the display.
Pan slaving sets the Flex Bus's panning in the cue bus to be
the same as it is in the main mix.
They can also be set on the
PARAM VIEW on Fader
screen (p. 64).
When the level for MAIN
OUT feeding of the same
flex bus is the minimum,
feeding to a cue bus is not
outputted too. (Refer to the
block diagram attached to
the processor.)