Roland VM-C7100 Owner's Manual page 156

Parameter (full name)
Lo-Fi Processor:
Sw (Switch)
Effect Level (Effect Level).
Direct Level (Direct Level)
Rate (Rate)
Bit (Bit)
PreFilt (Pre Filter Switch)
PstFilt (Post Filter Switch)
Realtime Modify Filter:
Sw (Switch)
Gain (Gain)
Cutoff Freq (Cutoff Frequency)
Reso (Resonance)
Type (Type)
Noise Suppressor:
Sw (Switch)
Thresh (Threshold)
Release (Release)
Lo-Fi Processor (p. 239), Realtime Modify Filter (p. 243), Noise Suppressor (p. 240), LPF (p. 239), BPF (p. 233),
HPF (p. 238), Resonance (p. 243)
Setting
Creates lo-fi sounds.
On, Off
0–100
0–100
Off, 1/2 - 1/32
Off, 15 bits - 1 bit
On, Off
On, Off
Creates sounds with a twist.
On, Off
0–24 dB
0–100
0–100
LPF, BPF, HPF
Mutes noise in the silent mode.
On, Off
0–100
0–100
Chapter 8 Using the Internal Effects
Function
Turns the lo-fi processor on or off.
Sets the volume of the lo-fi sound.
Sets the volume of the direct sound.
Sets the sample rate.
Set Rate to "Off" if no change is desired.
Sets the number of bits in data.
Set Bit to "Off" if no change is desired.
Turns the filter to reduce digital distortion on or off.
Turns the filter to reduce digital distortion due to
modification to lo-fi sounds on or off.
Turns the realtime modify filter on or off.
Sets the volume of the realtime modify filter.
Sets the cutoff frequency.
Enhances the frequency components around cutoff
frequency.
Sets the filter type.
Turns the noise suppressor on or off.
Sets the level to start muting noise.
Sets the time over which the volume will drop to 0 after the
noise starts being muted.
155