Roland VM-C7100 Owner's Manual page 148

Parameter (full name)
Gate Reverb:
Sw (Switch)
Time (Gate Time)
Pre-Delay (Pre-Delay)
Thick (Thickness)
Density (Density)
Mode (Gate Mode)
Effect Level (Effect Level).
Direct Level (Direct Level)
Accent Delay (Accent Delay Time)
Accent Level (Accent Level)
Accent Pan (Accent Pan)
3 BAND EQ (Equalizer)
Sw (Switch)
Hi Gain (High Gain)
Hi Freq (high frequency)
Hi Q (High Q)
Hi Type (High Type)
Mid Gain (Middle Gain)
Mid Freq (middle frequency)
Mid Q (Middle Q)
Lo Gain (Low Gain)
Lo Freq (low frequency)
Lo Q (Low Q)
Lo Type (Low Type)
Output Level (Output Level)
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shelv (Shelving Type)," the setting for Lo Q or High Q
is invalid.
Frequency (p. 237), Q (p. 243), Shelving Type (p. 244), Peaking Type (p. 242), Equalizer (p. 236), Gate Reverb (p. 237)
Setting
Mutes the revert sound midway.
On, Off
10–400 s
0–300 ms
0–100
0–100
See the column on
the previous page.
-100–100
-100–100
0–200 ms
0–100
L63–R63
On, Off
-12– +12 dB
1.4–20.0 Hz
0.3–10.0
Shelv, Peak
-12– +12 dB
200–8000 Hz
0.3–10.0
-12– +12dB
20 - 2000 Hz
0.3–10.0
Shelv, Peak
0–100
Chapter 8 Using the Internal Effects
Function
Turns the gate reverb on or off.
Sets the time from when the reverb sound begins until it is
muted.
Sets the time until the reverb sound appears.
Sets the thickness of the reverb sound.
Sets the density of the reverb sound.
Defines how the reverb sound is applied.
Sets the volume of the gate reverb sound.
Sets the volume of the direct sound.
Sets the time from when the reverb sound is muted until the
accent sound appears.
Sets the volume of the accent sound.
Sets the pan of the accent sound.
Turns the equalizer on or off.
Sets the boost/cut amount in the high frequency band.
Sets the center frequency in the high frequency band.
Sets the width of the area around the high frequency that
will be affected by the gain settings.
Sets the type of the high frequency band equalizer
(shelving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.
Sets the type of the low frequency band equalizer
(shelving type or peaking type).
Sets the volume after passing through the equalizer.
*1
*1
147