Roland VM-C7100 Owner's Manual page 144

Parameter (full name)
Flanger:
Sw (Switch)
Rate (Rate)
Depth (Depth)
Manual (Manual)
Reso (Resonance)
Effect level (Effect Level).
Direct Level (Direct Level)
CrossFB Level (Cross-Feedback Level)
Polarity (Polarity)
3 BAND EQ (Equalizer)
Sw (Switch)
Hi Gain (High Gain)
Hi Freq (high frequency)
Hi Q (High Q)
Hi Type (High Type)
Mid Gain (Middle Gain)
Mid Freq (middle frequency)
Mid Q (Middle Q)
Lo Gain (Low Gain)
Lo Freq (low frequency)
Lo Q (Low Q)
Lo Type (Low Type)
Output Level (Output Level)
*1: An excessively great values for Resonance (Reso) may cause oscillation.
*2: An excessively large value for Cross-Feedback level may cause oscillation.
*3: When a mono source has been input, set "Inv" to provide spaciousness to the sound. Set "Sync" for inputting a
stereo source.
*4: If Low Type (Lo Type) or High Type (Hi Type) is set to "Shelv (Shelving Type)," the setting for Lo Q or High Q
is invalid.
Frequency (p. 237), Q (p. 243), Shelving Type (p. 244), Peaking Type (p. 242), Flanger (p. 236), Equalizer (p.236),
Resonance (p. 243), Feedback Level (p. 236)
Setting
Adds effect similar to ascending/descending sound of a jet.
On, Off
0.1–10.0 Hz
0–100
0–100
0–100
-100–100
-100–100
0–100
Sync, Inv
On, Off
-12– +12 dB
1.4–20.0 kHz
0.3–10.0
Shelv, Peak
-12– +12 dB
200–8000 Hz
0.3–10.0
-12– +12dB
20 - 2000 Hz
0.3–10.0
Shelv, Peak
0–100
Chapter 8 Using the Internal Effects
Function
Turns the flanger on or off.
Sets the rate at which the flanger is modulated.
Sets the depth of modulation.
Sets the center frequency subject to application of the
Flanger effect.
Enhances frequency components at around the center
frequency set with Manual.
Sets the volume of the flanger sound.
Sets the volume of the direct sound.
Sets the amount of the flanger sound to be returned to the
channel opposite to the one used for input.
Sets the right and left phases of modulation.
Turns the equalizer on or off.
Sets the boost/cut amount in the high frequency band.
Sets the center frequency in the high frequency band.
Sets the width of the area around the high frequency that
will be affected by the gain settings.
Sets the type of the high frequency band equalizer
(shelving type or peaking type).
Sets the boost/cut amount in the middle frequency band.
Sets the center frequency in the middle frequency band.
Sets the width of the area around the middle frequency that
will be affected by the gain settings.
Sets the boost/cut amount in the low frequency band.
Sets the center frequency in the low frequency band.
Sets the width of the area around the low frequency that
will be affected by the gain settings.
Sets the type of the low frequency band equalizer
(shelving type or peaking type).
Sets the volume after passing through equalizers.
*1
*2
*3
*4
*4
143