Roland VM-C7100 Owner's Manual page 45

5. Confirm selection.
After selection, press [F2] (CP/LOAD) to copy the contents of the library to the
channel delay. After this operation, the settings cannot be returned to their state
prior to copying.
How to call up the copy/save screen for each library
The following library screens can be called up by pressing [COPY/LIBRARY] in
Steps 2 and 3 on the previous page (press a desired channel in place of [CH EDIT]):
• Channel library
Press STATUS [CH VIEW] while holding down [CH EDIT].
• Channel delay library
Press STATUS [PREAMP GAIN] while holding down [CH EDIT].
Press STATUS [DELAY] while holding down [CH EDIT].
• Channel equalizer library
Press STATUS [EQ GAIN] while holding down [CH EDIT].
Press STATUS [HPF/LO] while holding down [CH EDIT].
Press STATUS [LO-MID] while holding down [CH EDIT].
Press STATUS [HI-MID/HI] while holding down [CH EDIT].
Screen operations are the same for all libraries.
Saving the current settings into a library
In the following descriptions, the delay library is again used as an example. (Since
Step 2 differs for the equalizer or channel library, refer to the column above.)
1. Make sure that [INPUT] or [MULTI IN] is selected under SECTION.
2. Call up the delay channel edit screen.
While holding down [CH EDIT] of the channel whose library is to be copied or
saved, press the status button marked [PREAMP GAIN] or [DELAY].
3. Press [COPY/LIBRARY].
This opens the channel delay library.
fig.03-02
Chapter 3 Data Storage and Retrieval
In Step 4, INPUT or MULTI
IN can be selected instead
of U or P, and the V2 knob
can be used to select the
channel (1 to 24).
Proceeding to Step 5 (CP/
LOAD) in this state enables
the settings of the library to
be copied from the selected
channel to channel whose
[CH EDIT] is turned on.
45