Roland VM-C7100 Owner's Manual page 211

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
Changing the current position
Use the TIME/VALUE dial to change the current position. The current position is
shifted by either hour, minute, second or frame unit. To change the unit, press
CURSOR [LEFT]/[RIGHT]
Displaying scaled-up/down VIEWER area
1. Press CURSOR [DOWN]/[UP]
section.
2. Turn the [V5] knob to scale up/down the display along the time axis.
By increasing the value, you can focus on data in a specific section. By
reducing the value, you can confirm overall data changes.
3. To change the number of channels to be displayed at a time, turn the [V6]
knob.
Confirming all types of data
Normally, only the specified types of data are displayed for easy viewing.
Alternatively, however, you can check all types of data recorded.
1. Press
CURSOR [DOWN]
VALUE TRIM section.
2. Press [F2] (ALL) to set it on.
This makes the setting of the data types specified with the [V2] (PARAM)
knob invalid.
3. Turn the [V4] (EVENTSEL) knob to confirm data.
Regardless of the data type, all recorded data is displayed for confirmation
one by one. If more than one item of data exists at the same location, keep
turning the [V4] (EVENTSEL) knob to confirm them one by one.
4. To return to the screen displaying only the specified types of data, press [F2]
(ALL) to set it off.
210
while holding down [SHIFT].
to move the cursor over to the ZOOM
to move the cursor over to the VIEW/SOURCE/