Roland VM-C7100 Owner's Manual page 178

Compressor:
Sw (Switch)
Hi Thres (High Threshold)
Hi Raito (High Ratio)
Hi Atck (High Attack)
Hi Rel (High Release)
Lo Thres (Low Threshold)
Lo Ratio (Low Raito)
Lo Atck (Low Attack)
Lo Rel (Low Release)
Mixer:
Lo Level (Low Level)
Hi Level (High Level)
Limiter:
Sw (Switch)
Thres (Threshold)
Attack (Attack)
Release (Release)
Output:
Output Level (Output Level)
Sft Clip (Soft Clip)
Bass Cut Filter (p. 233), Enhancer (p. 236), Expander (p. 236), Compressor (p. 233), Limiter (p. 238)
Compresses the entire output signals when the input volume exceeds a
specified value.
On, Off
-24–0 dB
1:1–16:1, INF:1
0–100 ms
50–5000 ms
-24–0 dB
1:1–16:1, INF:1
0–100 ms
50–5000 ms
Adjusts the volume by frequency band.
-80– +6 dB
-80– +6 dB
Prevents distortion by suppressing signals at high levels.
On, Off
-24–0 dB
0–100 ms
50–5000 ms
Provides settings concerning overall output.
-80– +6 dB
On, Off
Chapter 8 Using the Internal Effects
Turns the compressor on or off.
Sets the volume at which the compressor for the high
frequency band starts working.
Sets the ratio at which the output in the high frequency
band is suppressed when the input level has exceeded the
high threshold level.
Sets the time until when the high frequency band
compressor starts working after the input level has
exceeded the high threshold level.
Sets the time until when the high frequency band
compressor stops working after the input level has dropped
below the high threshold level.
Sets the volume at which the compressor for the low
frequency band starts working.
Sets the ratio at which the output in the low frequency band
is suppressed when the input level has exceeded the low
threshold level.
Sets the time until when the low frequency band
compressor starts working after the input level has
exceeded the low threshold level.
Sets the time until when the low frequency band
compressor stops working after the input level has dropped
below the low threshold level.
Sets the volume in the low frequency band after passing
through expander and compressor.
Sets the volume in the high frequency band after passing
through expander and compressor.
Turns the limiter on or off.
Sets the volume at which the limiter starts working.
Sets the time until when the limiter starts working after the
input level has exceeded threshold level.
Sets the time until when limiter stops working after the input
level drops below the threshold level.
Sets the overall volume after passing through the limiter.
Suppresses conspicuous distortion that may occur when
the effect of compressor/limiter has been applied
excessively.
177