Roland VM-C7100 Owner's Manual page 182

EQ A/B (10-Band Parametric Equalizer)
Sw (Switch)
Input Level (Input Level)
Band 1 - 10 Gain (Bands 1 - 10 Gain)
Band 1 - 10 Freq (Bands 1 - 10 Frequency)
Band 1 - 10 Q (Bands 1 - 10 Q)
Output Level (Output Level)
Expander:
Sw (Switch)
Thres (Threshold)
Ratio (Ratio)
Attack (Attack)
Release (Release)
Compressor:
Sw (Switch)
Level (Level)
Thres (Threshold)
Ratio (Ratio)
Attack (Attack)
Release (Release)
• When returning the gain, the frequency, and Q of all bands to the default values, press [F3] (ALL RST). And when
returning the gain, frequency, and Q of the band selected currently to the default values, press [F5] (RESET). (PARAM-
1, 2 screen)
• When returning the input level and output level to 0, press [F3] (ALL RST). (PARAM-3 screen)
Q (p. 243), Frequency (p. 237), Bass Cut Filter (p. 233), Parametric Equalizer (p. 241), Expander (p. 236),
Compressor (p.233)
On, Off
-30.0– +15.0 dB
-15.0– +15.0 dB
-20– +20 kHz
0.3–16
-30.0– +15.0 dB
Expands the dynamic range at a certain ratio.
On, Off
-80–0 dB
1:1–16:1, INF:1
0–100 ms
50–5000 ms
Compresses the entire output signals when the input volume exceeds a
specified value.
On, Off
-80– +6 dB
-24–0 dB
1:1–16:1, INF:1
0–100 ms
50–5000 ms
Chapter 8 Using the Internal Effects
Turns the 10-band graphic equalizer on or off.
Sets the overall volume before passing through the
equalizer.
Sets the boost/cut amount by frequency.
Sets the center frequencies in the respective bands.
Sets the width of the area around the center frequency that
will be affected by the gain settings.
Sets the overall volume after passing through the equalizer.
Turns the expander on or off.
Sets the volume at which the expander starts working.
Sets the ratio at which the output is increased when the
input level has dropped below the threshold level.
Sets the time until when the expander starts working after
the input level has dropped below the threshold level.
Sets the time until when the expander stops working after
the input level has exceeded the threshold level.
Turns the compressor on or off.
Sets the volume of the compressor sound.
Sets the volume at which the compressor starts working.
Sets the ratio at which the output is suppressed when the
input level has exceeded the threshold level.
Sets the time until when the compressor starts working
after the input level has exceeded the threshold level.
Sets the time until when the compressor stops working after
the input level drops below the threshold level.
181