Roland VM-C7100 Owner's Manual page 135

Chapter 8 Using the Internal Effects
Parameter (full name)
Compressor: Compresses the entire output signals when the input volume exceeds a specified value.
Sw (Switch)
Output Level (Level)
Sustain (Sustain)
Attack (Attack)
Tone (Tone)
Heavy Metal/Distortion/Overdrive: Gives distortion to the sound.
Sw (Switch)
Output Level (Level)
Gain (Gain)
Lo Gain (Low Gain)
Mid Gain (Middle Gain)
Hi Gain (High Gain)
Tone (Tone)
Noise Suppressor:
Sw (Switch)
Thresh (Threshold)
Release (Release)
Auto Wah:
Sw (Switch)
Rate (Rate)
Depth (Depth)
Sens (Sense)
Freq (Frequency)
Peak (Peak)
Output Level (Level)
Mode (Mode)
Polarity (Polarity)
GAmpSim (Guitar Amplifier Simulator): Simulates Guitar Amplifier.
Sw (Switch)
Mode (Mode)
134
Setting
On, Off
0–100
0–100
0–100
-50–50
On, Off
0–100
0–100
-100–100
-100–100
-100–100
0–100
Mutes noise in the silent mode.
On, Off
0–100
0–100
Adds the wah effect.
On, Off
0.1–10.0 Hz
0–100
0–100
0–100
0–100
0–100
LPF, BPF
Up, Down
On, Off
See the column on
the previous page.
Function
Turns the compressor on or off.
Sets the volume of the compressor sound.
Sets the time over which low level signals are boosted to a
constant volume.
Sets the strength of attack when a sound is input.
Sets the tone color.
Turns the metal, distortion or overdrive on or off.
Sets the volume of the metal, distortion or overdrive sound.
Sets the degree of the distortion.
Sets the boost/cut amount in the low frequency band.
(only for Metal)
Sets the boost/cut amount in the middle frequency band.
(only for Metal)
Sets the boost/cut amount in the high frequency band.
(only for Metal)
Sets the tone color. (for Distortion/Overdrive only)
Turns the noise suppressor on or off.
Sets the level to start muting noise.
Sets the time over which the volume will drop to 0 after the
noise starts being muted.
Turns the auto wah on or off.
Sets the rate at which the wah effect will be cyclically modulated.
Sets the depth at which the wah effect will be cyclically modulated.
Normally "0."
Sets sensitivity for input volume changes for adding the
wah effect according to input volume changes.
Sets the frequency at which the wah effect starts working.
Sets the degree of the wah effect applied at around the
frequency.
Sets the volume of the wah sound.
Set to "BPF" for the wah effect in a narrow range of
frequencies and to "LPF" for wah effect in a broad range of
frequencies.
Activated only for adding the wah effect according to input
volume changes. Set to "Up" for moving the filter to a higher
frequency and "Down" for moving it to a lower frequency.
Turns the guitar amplifier simulator on or off.
Type of the guitar amplifier.