Roland VM-C7100 Owner's Manual page 214

7. Check IN/OUT to confirm the region to be copied.
To reset the region to be copied, reset REGION SET (p. 211).
8. Turn the TIME/VALUE dial to shift the current position to the reference
point in the source data (FROM).
Turning the TIME/VALUE dial shifts the current position by either hour, minute,
second, or frame units. To change the unit, press
while holding down [SHIFT].
9. Press [F1] (FROM) to assign the current position to FROM.
10.Turn the TIME/VALUE dial to shift the current position to the position in
the destination (TO).
11.Press [F2] (TO) to assign the current position to TO.
12.Turn the [V3] (DESTINATION) knob to select the channel to which data is
to be copied.
13.Turn the [V4] (INSERTION) knob to specify the copying method.
14.Turn the [V4] (TIMES) knob to specify how many times the data is to be
copied.
15.Press [F4] (EXEC) to execute COPY.
When COPY is completed, a "Complete" message is displayed.
16.Press [F6] (RETURN) and [F6] (EXIT), in this order, to return to the AUTO
MIX VIEW screen.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
CURSOR [LEFT] or [RIGHT]
It is also possible to assign
the position specified with
the locator to TO or FROM.
Instead of the TIME/
VALUE dial, press the
LOCATE button to shift the
current position.
To copy data to the same
channel as the source, this
setting does not have to be
changed.
To abort COPY, press
[EXIT] to return to the
VIEW screen.
Press [UNDO/REDO] to
cancel the copying
operation you have just
performed (UNDO).
Pressing [UNDO/REDO]
once more restores the
post-copy state (REDO).
213