Dcc Channel - New Ne Interface Parameters - Alcatel-Lucent 1850 User Provisioning Manual

Procedures
............................................................................................................................................................................................................................................................
Figure 5-32 DCC channel - filter by (contd.)
........................................................................................................................................................................................................................
7
Click the radio button to select the filtered DCC Channel and click Apply & Exit to
configure a new Network Interface as shown in
Figure 5-33 Create new network interface
........................................................................................................................................................................................................................
8
Table 5-19
Network Interface panel parameters:
Table 5-19 DCC channel - new NE interface parameters
Parameter
Access Identifier
Lower Layer Mode
OSI Protocol
............................................................................................................................................................................................................................................................
5 - 44

"DCC channel - new NE interface parameters"

Description
Specifies the Access Identifier of a resource for the selected
port
Specifies the protocol used for the Layer 2 over the specified
DCC. The values are:
•
•
Specifies if the OSI protocol runs on the addressed DCC or
not. The values are:
•
•
Figure 5-33.
LAPD
PPP
ENABLE
DISABLE
Create DCC Channel
provides description of New
8DG08763KAAA
Issue 1 February 2009