Alcatel-Lucent 1850 User Provisioning Manual page 162

Menu bar
............................................................................................................................................................................................................................................................
– The BACKUP-DATE and BACKUP-TIME on the RFS DB (represented in the
– The SID indicated on the RFS DB does not match the SID of the system.
– The software release/identifier indicated for RFS DB does not match the software
– Normal (default value) - The command is denied if there is a mismatch between
The Default hyperlink allows to set Normal automatically.
The Default hyperlink allows to set No automatically.
The panel has the Apply hyperlink that is used to apply the previously selections.
Cancel copy
This option interrupts an in-progress file transfer previously initiated by the Copy Remote
File option. A subsequent activation of this option will start a file transfer from the
beginning.
In case a remote upload file transfer is autonomously or manually canceled, partially
transferred files might exist on the RFS after an upload gets canceled. The system does not
take care of these remote files. It is the responsibility of the RFS maintained in this case to
do the clean up, or to reuse the same storage location for future backups by using the
overwrite option.
When this option completes successfully, the message indicates that the file transfer
initiated by the Copy Remote File option was not completed successfully.
In the case where a Copy Remote File option is executing with parameter OVWRT set to
Y, this option does not restore the data that was present before the Copy Remote File
option command started.
Select System Management -> DB Management -> Remote File -> Cancel Copy as
shown in
............................................................................................................................................................................................................................................................
3 - 96
label on the RFS database) is older/prior to the BACKUP-DATE and BACKUP-
TIME on the system (represented in label on the Active Hard disk Database)
release identifier indicated for the system.
the SID, the release identifier, system stream, system type or the backup time
stamp of the system and the information stored in the source database.
Figure 3-91.
System management menu
8DG08763KAAA
Issue 1 February 2009