Alcatel-Lucent 1850 User Provisioning Manual page 356

Procedures
............................................................................................................................................................................................................................................................
Parameter
Direction
User Name
In Label
Out Label
PHB Profile
Alarm Profile
Access Control Domain
Tunnel ID
Primary State
L2 Encapsulation Profile
........................................................................................................................................................................................................................
3
Click Select to select the MPLS Port as shown in
............................................................................................................................................................................................................................................................
5 - 92
Description
Specifies the Tunnel Segment Direction (BIDIR
or UNIDIRIN or UNIDIROUT)
Specifies the Tunnel Segment User name
Specifies the expected Label for incoming
segment associated to Sink Tunnel Segment.
This parameter is not relevant if
DIR=UNIDIROUT. The label value must be
unique in the system and in the range {1024-
1048575}
Specifies the transmitted Label for outgoing
segment associated to Source Tunnel Segment.
This parameter is not relevant if
DIR=UNIDIRIN. The label value must be
unique on MPLS port basis and in the range
{1024-1048575}
Specifies the AID of PHB Profile resource
Specifies the Alarm Severity Assignment Profile
(ASAP) name to use with this Tunnel Segment
This is local or Control Plane
Identifies the Tunnel automatically generated for
Terminated Tunnel Segment
Specifies the administrative state, IS/OOS
(default IS)
Specifies the L2 Encapsulation profile AID to be
used in case of mapping of MPLS over Ethernet
when a switched network is present. This
parameter is relevant only if port parameter
refers to Local MPLS Interface
Figure 5-67.
Modify tunnel
8DG08763KAAA
Issue 1 February 2009