Table of Contents
Advertisement
Menu bar
............................................................................................................................................................................................................................................................
Figure 3-82 System management - In-service upgrade - stop
The panel shows the status of the in-service upgrade. The possible status are the same
described in
Upgrade? field.
The panel has the Apply hyperlink that is used to stop the in-service upgrade process.
In-service upgrade and remove old upgrade
This option makes the current release software the permanent active software. It
effectively prevents reversion to a previous release once it is determined by the operator
that the capability is no longer required.
After successful completion of this command, all software/database indicators are set to
indicate that the current release is now the permanently active one. The system remains in
service on the currently active release and all system functionality remains operational.
Select System Management -> Initialize and Upgrade -> In-Service Upgrade ->
Remove Old Upgrade as shown in
Figure 3-83 System management - In-service upgrade - remove old upgrade
The panel shows the status of the in-service upgrade. The possible status are the same
described in
Service Upgrade? field.
The panel has the Apply hyperlink that is used to remove the old upgrade process.
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
In-service upgrade and start
In-service upgrade and start
upgrade, but it presents the Stop In-Service
Figure
3-83.
upgrade, but it presents the Remove In-
System management menu
3 - 8 5
Advertisement
Chapters
Table of Contents
