Alcatel-Lucent 1850 User Provisioning Manual page 275

Procedures
............................................................................................................................................................................................................................................................
Parameter
User Label
Service Type
Flow Type
Traffic Descriptor
Layer 2 control frames (0x)
Actual Layer 2 control frames (0x)
Policing Mode
Color Profile
VLAN Profile
VLAN pop
Classification mode
Classifier Panel
Classifier index
State
Configuration Type
Priority Bits
VLAN
Ether Type
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
Description
Allows to indicate the LAG by means of a name
defined by the user.
Identifies the type of cross-connection
Identifier the Flow type of the cross-connection
Specifies the Traffic Descriptor for the cross-
connection
Allows to enable or disable the Protocol Frames
that can accede the port
Refers, how to enable or disable the Protocol
Frames that can accedes the port
Refers about the policing of the incoming ETS
traffic.
Specifies the association between incoming S-
VLAN priorities and forwarded frames coloring
(for scheduling purpose inside the bridge)
If enabled, it pops out the S-VLAN shim fields
of the ethernet frame
Description
Specifies an incremental index assigned by the
system to the resource
Specifies the notification about the actual status
of the resource. The values are active and not
active
Specifies the transmission parameters of the
Alcatel-Lucent 1850 TSS data node
Specifies the prioritization of an Ethernet data
flow on the 3 user priority bits (802.1p) of the
Tagged-Ethernet frame and also on the 3
provider priority bits of the Stacked-VLAN
frame
Specifies the indexed value assigned by the
system to this profile
Specifies the stacked-VLAN identifier that is
pushed into the Ethernet frame
Create LAG
5 - 1 1