Dcn Physical Interface Page - Lan Management - Alcatel-Lucent 1850 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
IP Address (Internet Protocol address) - This is the IP address of the NE. The entry
•
box allows to digit the IP address of the NE (value range [1-99, 101-126,128-223] - [0-
255] - [0-255] - [0-254]).
Subnet Mask - This is the entry box for subnet mask of the network the NE is
•
connected to (value range [128-255] - [0-255] - [0-255] - [0-255]). The mask, in binary
representation, must contain a contiguous string of 1s (the network portion) and a
contiguous string of 0s (the host portion).
The Save hyperlink closes the page and returns back to the previous page.
LAN management
This option allows the operator to modify the various network interface parameters
associated with the customer LAN.
Select Xcom -> DCN Phys. If -> LAN manag. option as shown in
Figure 3-49 DCN physical interface page - LAN management
The Customer LAN Management tab displays the Customer LAN Management panel
that contains the following parameters:
OSI Protocol - Determines if the OSI Protocol will be run on the customer LAN or
•
not. The values are:
– N (OSI Protocol is disabled on the Customer LAN)
– Y (OSI Protocol is enabled on the Customer LAN)
Internet Protocol - Determines if the Internet Protocol will be run on the customer
•
LAN. The values are:
– N (Internet Protocol is disabled on the Customer LAN)
– Y (Internet Protocol is enabled on the Customer LAN)
OSI Area - This is possible to enter as to which OSI Area the Customer LAN belongs
•
to ("1", if OSI was disabled previously, previously existing value, otherwise).
Integrated ISIS - Determines if the Integrated IS-IS Protocol will be run on the
•
customer LAN or not. The values are:
– N (Integrated IS-IS Protocol is disabled on the customer LAN)
– Y (Integrated IS-IS Protocol is enabled on the customer LAN)
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
Xcom menu
Figure 3-49.
3 - 5 5