Alcatel-Lucent 1850 User Provisioning Manual page 232

Tree area
............................................................................................................................................................................................................................................................
Figure 4-24 VCG on PP10AD
The Rack x > Shelf x > Board xx tab displays the following parameters:
Access Identifier - Specifies the Access Identifier for the VCG entity.
•
Current Provisioned Type - Specifies the acronym of the circuit pack resource. It is
•
the Alcatel-Lucent mnemonic stored in the Remote Inventory EPROM for the given
equipment. ANY-<type> is the value shows for a generic non Alcatel-Lucent
XFP/SFP module.
Actual Type - Specifies the acronym of the physically equipped module type.
•
Primary/Secondary state - Specifies primary and the secondary service state.
•
Primary state - To change the primary service state previously referred and described.
•
Automatic In Service Mode - To set the Automatic in service mode to which the
•
equipment is set. The choices are:
– NOWAIT - A condition notifies the module is unplugged
– AINS - A condition is sent due to module unplugged
Auto-Provisioning - Specifies the Auto provisioning parameter is used to manage the
•
Autoprovisioning functionality in case of global (Shelf/NE level) restart: its main
purpose is to prevent the autoprovisioning of a Card (after a restart) in a slot position in
which it has been Logically Deleted. It cannot be provisioned, it is managed only by
the NE but can be retrieved. The choices are:
............................................................................................................................................................................................................................................................
4 - 34
Access a module
8DG08763KAAA
Issue 1 February 2009