Table of Contents
Advertisement
Procedures
............................................................................................................................................................................................................................................................
Parameter
User Label
Size
Actor Admin Key
Type
EthClient Type (read only
field)
Actor System Priority
ASAP Name
MTU (Maximum Transmit
Unit)
VLAN Protocol Profile
Encaps Method
LACP Enabled
LACP Type
........................................................................................................................................................................................................................
3
Click Save hyperlink that applies the user's operation in this page
............................................................................................................................................................................................................................................................
5 - 6
Description
Allows to indicate the LAG by means of a name defined by
the user.
Allows to set the size of the LAG, i.e. number of Aggregated
Ports; possible values are integers in the 1 to 16 range
Allows to indicate the LAG "Key", the parameter identifying
this LAG; integer in the 0 to 123 range
Refers about the type of port (read only field, fixed by the
system to ieee8023adLag)
Indicates the transported layer. The values are:
ets: for Ethernet Transparent System
•
etb: for Ethernet Bridge System
•
Allows to indicate the LAG Priority. This parameter, together
with the LAG Mac-Address, forms the "System Identifier".
The lowest System Identifier value will be elected as the
"Master" of the link, i.e. the one that will drive the actions in
case of events such as failures, switches, etc. The valid range
is 0-65535
Allows to set a name of alarms profile to be associated to the
current Port. The Select hyperlink allows to start the
selection
procedure.
After the selection procedure, the
chosen value will be reported
Allows to set the size of the largest packet which can be sent
on this LAG interface, specified in octets. The values are
integers in the 1574 to 9216 range
Allows to chose one of the existing VLAN Profile or setting
don't care
Refers about the method of MAC packets encapsulation
inside the underlying physical layer. The options are:
ethernetV2: default mode, set by the system
•
IEEE8023: not yet operative
•
The values are True or False
Indicates if the Link Aggregation Control Protocol is ON (i.e.
lacpOn is active on this aggregator) or OFF (IacpOff
inactive); read only field, fixed by the system
Create LAG
8DG08763KAAA
Issue 1 February 2009
Advertisement
Chapters
Table of Contents
