Eqps Selection Page - Alcatel-Lucent 1850 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
Figure 3-63 EQPS selection page
The Equipment Protection Switch tab displays the Equipment Protection Switch panel
that contains the following parameters:
– Access Identifier - Specifies in the <unit acronym> - <rack> - <shelf> - <slot>
– Primary/Secondary State - Specifies the state of the selected unit
– Command Mode - Combo-box allows to change the status of the unit. The values
The panel has the following hyperlinks:
– Cancel - This is used to delete the operation in the page and came back to the
– Manual Switch - This is used to manually switch the real status shown in the
– Inhibit Switch - This is used to avoid the automatic switch of the involved unit
The table contains the following columns:
– Slot - Specifies the slots where the protected and protecting units are housed
– Access Identifier - Specifies in the <unit acronym> - <rack> - <shelf> - <slot>
– Role - Specifies the real role of the unit. The values are Protecting or Working.
– Equipment Protection Status - Specifies the real status of the unit. The values are
LinearMSP
The LinearMSP displays the following as shown in
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
format, where the selected unit is housed
are NORM (normal) or FRCD (forced)
previous page
associated table
format, where it is housed
This column is related to the next column
Standby or Active. This column is related to the previous column
Figure 3-64.
Protection menu
3 - 6 9