Alcatel-Lucent 1850 User Provisioning Manual page 578

Appendix
............................................................................................................................................................................................................................................................
Command
SET-LAC-DFLT
SET-PMMODE-
GBE10
SET-PMMODE-
GBE
SET-PMMODE-
MAU
............................................................................................................................................................................................................................................................
6 - 18 4
Description
Used by a manager, CRAFT or
EML, to set the default value for
the following LAC
parameters.
Location specifies the location
where PM data collection is to be
enabled or disabled.
Mode Type, specifies the PM
mode type to be enabled or
disabled.
PM State, specifies whether the
PM data collection for the
specified mode type is enabled or
disabled.
Direction, specifies the direction
of the signal being monitored
(receive or transmit). Only the
value RCV is supported.
Location specifies the location
where PM data collection is to be
enabled or disabled.
Mode Type, specifies the PM
mode type to be enabled or
disabled.
PM State, specifies whether the
PM data collection for the
specified mode type is enabled or
disabled.
Direction, specifies the direction
of the signal being monitored
(receive or transmit). Only the
value RCV is supported.
Sets the mode of PM data
collection for the specified
facility.
Parameter defaults
Parameter Default
TID Entry Required
LOCN <Entry required>
MODETYP <Entry required>
E
PMSTATE ON
DIRN RCV
LOCN Mandatory
parameter
MODETYP Mandatory
E parameter
PMSTATE ON
DIRN RCV
TID Entry Required
Issue 1 February 2009
8DG08763KAAA