Create Head/Tail Tunnel - Alcatel-Lucent 1850 User Provisioning Manual

Procedures
............................................................................................................................................................................................................................................................

Create head/tail tunnel

Purpose
Use this procedure to create a new Head/Tail Tunnel.
........................................................................................................................................................................................................................
1
Select (T)MPLS -> Tunnel Management from the menu bar as shown in
Figure 5-63 Tunnel management - filter by panel
........................................................................................................................................................................................................................
2
Select Tunnel Location from the drop-down list to filter Tunnel information. It specifies
where the search must be executed. The values are ALL or all the shelves (i.e. SHELF-1-
1)
........................................................................................................................................................................................................................
3
Select Tunnel Type from the drop-down list that specifies the type of Tunnel to be filtered.
The values are:
– ALL - No filter applied
– LOCAL - All the tunnel related to Management Plane
– CP - All the tunnel related to Control Plane
– LOST - All the tunnel related to LOST
........................................................................................................................................................................................................................
4
Enable the Tunnel ID Filter check box to activate the entry box and enter the tunnel ID to
be filtered.
........................................................................................................................................................................................................................
5
Enable the Tunnel AID Filter check box to activate the entry box and enter the tunnel
AID to be filtered.
............................................................................................................................................................................................................................................................
5 - 84
Create head/tail tunnel
Figure 5-63.
8DG08763KAAA
Issue 1 February 2009